Eaton Cutler-Hammer MP-3000 - Page 27

I.L. 17562
Page 27
PR 0.3 Effective 8/99
Line
No.
Display Help Message Setpoint
Range/ Value
Selection
Value as
shipped
Selected Value
ZERO SW DETECTION
RST DBL – RESET DISABLE
EMG OVR – EMERGENCY
OVERRIDE
ZERO SW – ZERO SPEED
SWITCH
CONFIGURE DISCRETE
INPUT 1 –
ZERO SW – ZERO SPEED
SWITCH TO GET ANY OTHER
FUNCTION SET ZERO SPEED
SWITCH SETPOINT TO OFF
selected here,
P5L11 will be
forced to ZSW
ON.
If P5L11 was
already set to
ZSW ON, then
this setpoint is
automatically set
to ZERO SW
and no other
selections are
visible.
Page 7 SP DI 2 SETPOINTS FOR DISCRETE INPUT NUMBER 2
1 Choose:
REM RST
REM TRIP
DIF TRIP
MTR STOP
RST DBL
EMG OVR
INC SEQ
CONFIGURE DISCRETE
INPUT 2 - -
REM RST – REMOTE RESET
REM TRIP – REMOTE TRIP
DIF TRIP – DIFFERENTIAL
TRIP
MTR STOP – MOTOR STOP
DETECTION
RST DBL – RESET DISABLE
EMG OVR – EMERGENCY
OVERRIDE
INC SEQ – INCOMPLETE
SEQUENCE
CONFIGURE DISCRETE
INPUT 2 –
INC SEQ – INCOMPLETE
SEQUENCE TO GET ANY
OTHER FUNCTION SET
INCOMPLETE SEQUENCE
TIME SETPOINT TO OFF
Choose from the
seven selections
for the function
of Discrete Input
2.
If INC SEQ is
selected here,
P5L8 will be
turned on and
set to 1 second.
If P5L8 was
already set to a
time value (not
OFF), then this
setpoint is
automatically set
to INC SEQ and
no other
selections are
visible.
INC SEQ
Page 8 SP AREL SETPOINTS FOR ALARM RELAY OUTPUT CONFIGURATION
1 Choose:
GF A ON
GF T ON
or
GF OFF
ENABLE GROUND FAULT
ALARM OR TRIP TO
ACTIVATE ALARM RELAY
OUTPUT OR DISABLE
Toggles between
GF A ON, GF T
ON, and GF OFF
GF A ON
2 Choose:
I2T A ON
I2T T ON
or
I2T OFF
ENABLE I2T ALARM OR TRIP
TO ACTIVATE ALARM RELAY
OUTPUT OR DISABLE
Toggles between
I2T A ON, I2T T
ON, and
I2T OFF
I2T A ON
3 Choose:
JAM A ON
JAM T ON
or
ENABLE JAM ALARM OR
TRIP TO ACTIVATE ALARM
RELAY OUTPUT OR DISABLE
Toggles between
JAM A ON, JAM
T ON, and JAM
OFF
JAM A ON