105
EA(B)O-6X06 01/2018 Rev. 1 3. Disassembly and Assembly
38. Install the clutch release bearing sleeve (input shaft
bearing cover).
39. Install the four retaining capscrews of the clutch release
bearing sleeve. Tighten to the torque of 19-26 N.m (14-
19 Lb.ft). Use an 11mm hex socket.
6928
41. Install the oil drain plug.
NOTE: Apply Loctite 570 (Eaton E677) threadlocker
onto the plug thread. Tighten to the torque of 20-34
N.m (15-25 Lb.ft).
40. Install the clutch release fork, tting pivot points on the
ball studs.
6923
6926
If removed during disassembly:
42. Install the plug (1).
NOTE: Apply Dow Corning 780 sealant onto the plug
contact surface. Tighten to the torque of 19-26 N.m
(14-19 Lb.ft).
43. Install the oil ll plug (2).
NOTE: Apply Loctite 570 (Eaton E677) threadlocker
onto the plug thread. Tighten to the torque of 20-34
N.m (15-25 Lb.ft).
6952
1
2
Transmission Assembly
To Next Page
Loading...
