151
EA(B)O-6X06 01/2018 Rev. 1 4. Electro-Hydraulic Control Unit
0063-18
0064-18
0065-18
Selection Piston and Repair Kit
Replacement
Disassembly
1. With the reservoir sealed [see Preparation Before
Disassembly, operations 3 and 4, release the two
connectors of the solenoid valves to facilitate access
to the piston cover bolts.
2. Loosen only two Allen 5 mm bolts, diagonally opposite
on the piston cap, leaving them threaded with 5 threads.
CAUTION! After mounting the locking ring
rotate it inside its housing to make sure it
is properly installed.
Electro-Hydraulic Control Unit
Disassembly and Assembly
To Next Page
Loading...
