ELC Programming Manual
FOR MORE INFORMATION VISIT: WWW.EATON.COM MN05003003E
2-78
Insert time interrupt
ELC-PB, ELCB-PB Controllers =
I610~I699, ( Timer resolution:
1ms), 1 point
ELC-PC/PA/PH Controllers =
I601~I699, I701~I799, ( Timer
resolution: 1ms) , 2 points
ELC-PV controllers = I601~I699,
I701~I799, ( Timer resolution:
1ms); I801~I899, ( Timer
resolution: 0.1ms) , 3 points
ELCM-PH/PA controllers =
I602~I699, I702~I799, ( Timer
resolution: 1ms) , 2 points
High-speed counter
interruption
ELC-PC/PA/PH Controllers =
I010, I020, I030, I040, I050, I060,
6 points
ELC-PV Controllers = I010, I020,
I030, I040, I050, I060, 6 points
ELCM-PH/PA Controllers = I010,
I020, I030, I040, I050, I060, I070,
I080, 8 points
Pulse interruption
ELC-PV Controllers = I110, I120,
I130, I140, 4 points
Insert communication
interrupt
ELC-PB, ELCB-PB, ELC-
PC/PA/PH Controllers= I150, 1
point
ELC-PV Controllers = I150, I160,
I170, 3 points
ELCM-PH/PA Controllers = I140,
I150, I160, 3 points
The location point of
interrupt subroutine
Nest Level Pointer N: used with instruction MC and MCR. MC is master start instruction. When the
MC instruction is executed, the instructions between MC and MCR will be executed normally. MC-
MCR master instruction supports nested program structure and the maximum is 8 levels, which is
numbered from N0 to N7.
Pointer P: use with application instructions CJ, CALL, and SRET.
CJ condition jump:
When X0=ON, program will jump from 0 to N (designated label P1) and keep on executing without
executing the instructions between 0 and N.
When X0=OFF, program will execute from 0 and keep on executing the followings. CJ instruction
will not be executed at this time.
To Next Page
Loading...
