Need help?Do you have a question about the Eaton EPCT Fire Series and is the answer not in the manual?
General| Brand | Eaton |
|---|---|
| Model | EPCT Fire Series |
| Category | Controller |
| Language | English |
Covers aspects of installation, application, operation, and maintenance of the EPCT Fire Pump Controller.
Emphasizes strict observance of all safety codes, standards, and regulations during installation and operation.
Describes the EPCT Controller as a multi-function microprocessor-based fire pump controller meeting various certifications.
Details how the controller automatically starts and stops the fire pump motor based on programmed set-points.
Lists and describes the ten programmable inputs and their functions, including remote start, stop, and various conditions.
Details the Startup tab functions, including Quick Setup, Phase Reversal, Flow Test, Manual/Automatic start, and USB download.
Covers panel setup options like language, time, date, starting method, voltage, phases, frequency, and alarms.
Details programming for pressure settings: start/stop pressure, alarms, variance recording, and low suction/foam shutdown.
Explains programming for various timers including Minimum Run Time, Acceleration Timer, Sequential Start, and Fail timers.
Covers alarm configuration for Phase Reversal, Phase Failure, Motor Overload, Transducer Fail, and voltage/frequency alarms.
Details programming for optional inputs and outputs, including delay timers, latching, and failsafe configurations.
Details programming options for ATS time delays, engine start, cooldown, dual utility, and weekly engine test timers.
To Next Page