Eaton EPCT Fire Series - Weekly Engine Test Timer

22
Automatic transfer switch (ATS)
EPCT FIRE SERIES FIRE PUMP CONTROLLER MN124016EN August 2019 www.eaton.com
6.6.8 Weekly engine test timer
A Weekly Engine Test Timer can be programmed that
will automatically start and run the generator at specific
intervals. The Weekly Timer is set by adjusting the day, hour,
and minute of the desired weekly run time, the length of
time that this test shall be performed, a test interval (in
weeks), and the ability to transfer the load to Source 2.
While the weekly test timer is timing, the remaining time
will be displayed in the notification area.
Refer to section 5.8 and Appendix G.