10 Eaton Ferrups FX UPS P-164000906 Eaton Ferrups FX User’s Guide P-164000906—Rev 05
Figure 4. Anchor Bracket Installation
NOTE For ease of installation, complete the rear electrical connections before securing the
anchor brackets to the floor.
Each bracket has holes that enable it to be attached by screws to the floor. the anchor brackets are attached to
the base itself.
1. Select the location for the brackets at the floor intersection beside the intended UPS cabinet location,
2. Roll the UPS cabinet to its intended location.
3. Turn the leveling feet counter-clockwise until the cabinet is level.
4. Using the proper type of customer-supplied screws for the intended mounting surface, attach each
bracket to the floor. All screws must be properly driven into the structural material.
Anchor Bracket Installation
To Next Page
Loading...
