Eaton i-on30EX - Page 93

i-on40 & i-onEX Range 4. Administration
Page 87
If you want to program a remote control to control the output, see
page 93.
To Program On and Off Times for Latched Outputs
First make sure that the output you wish to use is programmed as Latched
= Yes (see steps 1 to 16 starting on page 84).
17. Press  until the display shows:


18. Press .
The display shows the time when
the output will turn on.


19. Key in the time when you want the
output to come on. Use the 24-hour
clock in the format hh/mm. If the
hours or minutes are “9” or less
then key in a leading zero. For
example: six minutes past seven in
the morning will be “07/06”.


20. Press .
The keypad gives a double “beep”
confirmation tone. The keypad
display shows:


21. Press  until the display shows:


22. Press .
The display shows the time when
the output will turn off.


23 Key in the time when you want the
output to go off. Use the 24-hour
clock in the format hh/mm. If the
hours or minutes are “9” or less
then key in a leading zero. For
example: six minutes past seven in
the morning will be “07/06”.

