Eaton Power Xpert Release PXR 10 - Page 45

41
9 Available protection settings
PXR TRIP UNITS FOR POWER DEFENSE MOLDED CASE CIRCUIT BREAKERS MN012007EN June 2018 www.eaton.com
Register
number
Bit
field
Mask
field
Set point
name R/W Format Value definition Unit
403017 Relay_config3 R/W Encoded TRIP_OVERLOAD_RELAY = 0x0001
TRIP_NEUTRAL_RELAY = 0x0002
TRIP_SHORTCIRCUIT_RELAY = 0x0003
TRIP_SHORTDELAY_RELAY = 0x0004
TRIP_INST_RELAY = 0x0005
TRIP_GROUND_RELAY = 0x0006
TRIP_MM_RELAY = 0x0007
TRIP_ALL_RELAY = 0x0008
ALARM_HL_ALARM_RELAY = 0x0010
ALARM_HL_LOAD_RELAY = 0x0011
ALARM_HIGHTEMP_RELAY = 0x0012
ALARM_GROUND_RELAY = 0x0013
ALARM_THERMAL_RELAY = 0x0014
ALARM_WATCHDOG_RELAY = 0x0015
ALARM_LOW_BAT_RELAY = 0x0016
ALARM_INTERNAL_FAULT_RELAY = 0x0017
ALARM_STP_ERROR_RELAY = 0x0018
ALARM_BRK_HEALTH_RELAY = 0x0019
ALARM_COMM_FAULT_RELAY = 0x001A
ALARM_ALL_RELAY = 0x001B
AUX_RELAY = 0x0020
BELL_RELAY = 0x0021
MM_ACTIVE_RELAY = 0x0022
ZSI_ACTIVE_RELAY = 0x0023
ZSI_INPUT_RELAY = 0x0024
ZSI_OUTPUT_RELAT = 0x0025
COMM_OPEN_RBK_RELAY = 0x0026
COMM_CLOSE_BRK_RELAY = 0x0027 OUTPUT_1_
RELAY = 0x0028
OUTPUT_2_RELAY = 0x0029
403018 Pole location -
phase a(1)
R/W Encoded Pole location - phase A(1)
0 - left
1 - right
403019 Reserved
403020 Reserved
403021 Reserved
Set points group 1: protection group
Register
Bit
field
Mask
field
Set point
name R/W Format Value definition Unit
403000 15-0 Password W “0000”
403001 15-0 0xFFFF Group 0 =
system
R/W 0x00FF
403002 12-0 0x1FFF Rating
information
R Encoded PD2: PD3A: 125, 250, 400.
PD3B: 400, 600, 630.
PD4: 800, 1000.
PD5:
PD6:
A
403003 2-0 0x0007 Break frame R Encoded 00 --> NRX NF
01 --> NRX RF
11 --> NZM2
12 --> NZM3
13 --> NZM4
21 --> PD2
22 --> PD3-A
23 --> PD3-B
24 --> PD4
25 --> PD5
26 --> PD6