EasyManuals Logo

Eaton Power Xpert Instructions

Eaton Power Xpert
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Connecting a NetComm Wireless NTC-140W Router to an Eaton® Network Card P-164000722—Rev 04 1
CCoonnnneeccttiinngg aa NNeettCCoommmm WWiirreelleessss NNTTCC--114400WW SSeerriieess RRoouutteerr ttoo aann EEaattoonn® NNeettwwoorrkk CCaarrdd
IInnttrroodduuccttiioonn
This document provides instructions for connecting a NetComm Wireless NTC-140W Series wireless router to
one of the following Eaton connectivity cards:
Power Xpert Gateway UPS (PXGX-UPS)
Power Xpert Gateway Minislot UPS (PXGMS)
Gigabit Network (Network-M2)
PPrreerreeqquuiissiitteess
Eaton UPS with a PXGX-UPS, PXGMS, or Network-M2 card
PuTTy or HyperTerminal software
USB-to-USB (Type B) cable for PXGX-UPS
USB-to-USB (MiniTypeB) for PXGMS
USB-to-USB (MicroUSB B) for Network-M2
Serial COM port or USB-to-serial 9-pin male adapter
An existing PredictPulse account (refer to the PredictPulse Quick Start Guide)
NNTTCC--114400WW SSeerriieess RRoouutteerr IInnssttaallllaattiioonn GGuuiiddeelliinneess
Refer to the Quick Start Guide provided with the NetComm Wireless NTC-140W series router for instructions
on mounting the router and connecting power.
NOTE The router must be powered by a 120V outlet powered by the UPS. This ensures that
the router is protected during a power outage.
CCoonnnneeccttiinngg tthhee RRoouutteerr ttoo aa PPXXGGXX--UUPPSS oorr PPXXGGMMSS CCaarrdd
Connect the NTC-140W Series router and Eaton network card. Use the included Ethernet cable or equivalent.
For a PXGX-UPS card, connect the Ethernet cable from the LAN port on the NTC-140W Series router to
the Upstream port on the card (see Figure 1):
For a PXGMS card, connect the Ethernet cable from the LAN part on the NTC-140W Series router to the
Ethernet 10/100 port on the card (see Figure 2)
Route the Ethernet cable into the UPS via the appropriate conduit holes. Once connected, the LEDs on the
active Ethernet port, as well as the green Power LED and Status LEDs should light.
Figure 1. Power Xpert Gateway UPS (PXGX-UPS) Card

Other manuals for Eaton Power Xpert

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Eaton Power Xpert and is the answer not in the manual?

Eaton Power Xpert Specifications

General IconGeneral
ConnectivityEthernet, Serial
Enclosure RatingIP20
ProtocolsModbus TCP, Modbus RTU
Data LoggingYes
Alarm ManagementYes
Web InterfaceYes
Power Supply24 VDC
Humidity Range5% to 95% non-condensing

Related product manuals