Eaton PowerXL DM1 Series - Step 2 - PowerXL DM1 connection process; Creating a network

3
Step 2 - PowerXL DM1 connection process to PowerXpert inControl PC tool
POWERXL DM1 SERIES ADJUSTABLE FREQUENCY DRIVES PUB53696—August 2020 www.eaton.com
Step 2 - PowerXL DM1 connection process
to PowerXpert inControl PC tool
To set up a network, it will require a communication
DTM supported by the device DTM being connected to.
Determine the communication network being used in your
system; Eaton currently supports modbus serial and modbus
TCP communication protocols for connecting to its devices.
Creating a network
The framework will show the installed communication
modules that are installed along with the saved network
name.
Determine what network is being used to connect to the
device. To add that network DTM shown in the device
catalog there are a few options.
Drag the communication DTM from the Device Catalog to
the Network name.
Figure 4. Dragging the communication adapter to create
a network.
Press the sign in the device catalog.
Figure 3. Available communication adapters