2
Forward
This manual illustrates and describes the recommended pro-
cedure for servicing the CM2 and CM3 series valves.
Valves of the -30 design will be referred to throughout this
manual, but this information is essentially the same for the -20
design valves. Service parts are generally interchangeable be-
tween the -20 and -30 design valves, however, it is recom-
mended that the catalogs referenced in Table I be consulted for
service parts for the respective design. Customers who wish to
incorporate -30 design sections in -20 design valves can do so
without concern. In this instance, a tie bolt must be left out. This
does not affect the operation or function of the valve as one tie
bolt on the -20 design is redundant.
To service these valves, read this manual thoroughly, and fol-
low the instructions carefully.
Comments or suggestions concerning this publication may be
direct to the Mobile Service Department of Vickers.
EEaton Hydraulics, Incorporated 2000
All Rights Reserved
To Next Page
Loading...
