8
EATON IB053008EN Installation instructions
WaveLinx Wireless Area Controller (WAC)
8. After all WaveLinx devices have joined the Construction Group and illustrated the above behavior.
Press the “PAIR” button on the WAC a second time to leave the Construction Grouping mode,
The WAC will leave Construction Grouping automatically after 30 minutes if the “PAIR” button is not pressed a second
time.
The IEEE 802.15.4 wireless network LED on the WAC will be ON
9. After leaving the Construction Group mode the WaveLinx devices will behave in the following manner.
Luminaires with integrated sensors
Luminaire dims to 75%
All luminaires turn ON when the first occupancy sensor senses motion
All luminaires turn OFF when the last occupancy sensor times out unoccupied
All wallstations in the default area
control all luminaires together.
All integrated sensors, Tile Mount and Ceiling sensors create an occupancy group
Tile Mount Sensor.
Connected luminaire dims to 75%
All luminaires turn ON when the first occupancy sensor senses motion
All luminaires turn OFF when the last occupancy sensor times out unoccupied
All wallstations in the default area
control all luminaires together.
All integrated sensors, Tile Mount and Ceiling sensors create an occupancy group
Relay with 0-10V
Connected luminaires dim to 75%
All wallstations in the default area
control all luminaires together.
All luminaires turn ON when the first occupancy sensor senses motion
All luminaires turn OFF when the last occupancy sensor times out unoccupied
Relay turns ON/OFF based on occupancy
Receptacle
The controlled outlet will turn ON/OFF based on occupancy
Wallstation
All wallstations in the default area will control all luminaires in the default area based on out-of-the-box scene
definitions.
Ceiling Sensor
The LED on the sensor will flash when detecting occupancy
All integrated sensors, Tile Mount and ceiling sensors create an occupancy group
Connecting the Wireless Area Controller to the Building LAN
1. Wired Connection - Building LAN connection
Connect the WAC to the building PoE switch or PoE injector into the normal network.
Physical connection to the building LAN and receiving an IP address will automatically disable the wireless connection
method
WAC’s will automatically receive a DHCP IP address when connected to the building LAN
WAC device name will be: Eaton-xxxxxxxxxxxx on the building network
(where **** are all twelve characters of the unit MAC address found on the label at the bottom front of the WAC
plus 1)
To Next Page
Loading...
Need help?
General
