9
EATON IB053008EN Installation instructions
WaveLinx Wireless Area Controller (WAC)
Using the WAC internal web page,
Change the default name of the WAC
Statically assigning the IP address of the WAC
2. Wireless Connection - Building Wireless connection
WAC device name will be: Eaton-xxxxxxxxxxxx
(where **** are all twelve characters of the unit MAC address found on the label at the bottom front of the WAC
plus 1)
Using the WAC internal web page,
Enter the building wireless login credentials.
Building wireless login credentials are secured in the WAC by secure web pages and encryption during
storage.
Change the default name of the WAC
Statically assigning the IP address of the WAC
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS:
1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE
2. THIS DEVICE MUST ACCEPT
This device complies with Industry Canada™s licence-exempt RSSs. Operation is subject to the following two conditions:
1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d™Industrie Canada applicables aux appareils radio exempts de licence.
L™exploitation est
Autorisée aux deux conditions suivantes:
1. l™appareil ne doit pas produire de brouillage, et
2. l™utilisateur de l™appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d™en
compromettre le fonctionnement.
To maintain compliance with the RF exposure guidelines, place the unit at least 20cm from nearby persons.
Pour assurer la conformité aux directives relatives à l’exposition aux frequencies radio, le jouet doit êtreplacé à au moins
20_cm des personnes à proximité.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate this equipment.
To Next Page
Loading...
Need help?
General
