13
WaveLinx User Manual
www.eaton.com/wavelinx
4: Place devices into pairing mode. See the below chart for information on how to place specific devices in pairing mode:
Device Type How to place pairing mode
WaveLinx Wireless Dimming Switchpack
(WSP-MV-010: 120-277VAC model)
Cycle the power (switch OFF and then ON) of each identified circuit using the circuit breakers. This places the
devices into pairing mode and starts their search for a Wireless Area Controller. Pairing mode automatically
times-out after 60 minutes if a device does not successfully pair with a Wireless Area Controller. Only unpaired
devices will enter pairing mode on the power cycle.
Note: Standard WaveLinx Wallstations (line voltage powered) will also respond to this pairing technique.
WaveLinx Integrated Sensor
WaveLinx Tilemount Sensor
WaveLinx Industrial Integrated Sensor
WaveLinx Outdoor Integrated Sensor
To Next Page
Loading...
