61
WaveLinx User Manual
www.eaton.com/wavelinx
Viewing and Adjusting Individual Sensor Settings
Specific settings are adjusted at the sensor level including adjusting sensitivity, enabling and disabling the occupancy functions of a
sensor, and enabling and disabling the occupancy sensor’s LED. It is also possible to view the occupancy set the sensor belongs to, the
programmed hold time, the current sensor status, the battery level for battery powered ceiling sensors. Integrated sensors may also be
placed into temporary test mode and be placed in blink to identify mode (these features not supported in battery powered ceiling sensors).
To view or adjust the sensor’s settings:
Step 1: Open the WaveLinx Mobile Application and establish a connection with the Wireless Area Controller as the administrator user.
Step 2: In the areas list, select the area that contains the desired occupancy sensor.
Step 3: In the area screen, locate the desired device. WaveLinx Ceiling Sensors will appear in the in area device section while fixture
integrated sensors will appear within the assigned zone. Tap the desired device to open the configuration screen.
To select an integrated sensor, tap
the zone the fixture is located in
To select a ceiling sensor,
tap the sensor
Within the zone, tap the
desired integrated sensor
To Next Page
Loading...
