Eaton WaveLinx - Deleting Occupancy Sets

70
WaveLinx User Manual
www.eaton.com/wavelinx
Deleting Occupancy Sets
It is possible to remove occupancy sensor control from an area by deleting the occupancy set. Areas that do not have zones assigned to
occupancy sets will respond solely to other devices assigned, i.e. wallstation commands, schedule event commands, and daylight set
commands.
To delete an occupancy set:
Step 1: Open the WaveLinx Mobile Application and establish a connection with the Wireless Area Controller as the administrator user.
Step 2: In the areas list, select the area that contains the desired occupancy set.
Step 3: In the area screen, select the gear icon in the upper-right corner to open the area menu and then select the occupancy set option.
Select the gear icon to
open the area menu
Select the occupancy
sets option