20 XN-322-16DIO-PC05 digital input/output module
20.4 Technical data
XN300 slice modules 02/24 MN050002EN Eaton.com 136
20.4 Technical data
20.4.1 Digital inputs
20.4.2 Digital outputs
Designation
Number of channels 8
61131-2 Type1
Input voltage UE 24 Vdc maximum 30 VDC
Signal level LOW: 0 < UE < +8 V HIGH: +14 V < UE < +30 V
Switching threshold normally +11 VDC
Input current at UE=24Vdc normally 3.7 mA
Typical input delay
Input 1-4 1 s
Input 5-8 5ms
Input frequency for inputs 1-4 Max. 25 kHz
Counter frequency for inputs 1-4 Max. 25 kHz for event counting
Max. 100 kHz for X4 encoding
PWM time measurement for inputs 1-4
Measures the time between edge changes in sec.
Quantity 8
Short-circuit proof as per EN 61131-2 Yes
Power supply for digital outputs
Number of supply voltages 1 (X5, pin on connector 24)
Rated operating voltage U
e
24 Vdc
admissible range 18 – 30 VDC
Maximum permissible total current for all output
channels when using a duty factor of 100%
4A
Protection against polarity reversal
no
Voltage monitoring
Yes
Output characteristic data
„1“ signal
Output voltage (U
e
- 1V) < U
a
< U
e
Output current per channel 0.5 A
„0“ signal
Output voltage < 1 VDC
Max. output current per channel
10 A
Switching-on delay < 100 s
Switch off delay < 150 s
Maximum breaking energy of outputs (inductive
load)
1 Joule/channel
To Next Page
Loading...
