Getting the most from your Ebac 2000
1. It is preferable to leave the unit on standby 24 hours a day even if it is not running. This
enables the Smart Control system to keep monitoring your home.
2. Ensure internal doors are kept ajar where possible to allow air circulation.
3. Ensure external doors and windows are kept closed as much as possible. This also saves
wasting heat from your home.
4. Ensure the unit is positioned on a flat, even surface.
Positioning your Ebac 2000
Your dehumidifier should be positioned as near as is practical to condensation or dampness.
The dehumidifier will perform better in the coldest parts of your home and should not be close
to a radiator or other heat source.
Setting the controls
CONTROL PANEL
1. Humidistat Increase
2. Humidistat Decrease
3. Fan Speed & Air Cleaning Control
4. Mode Button
5. Amber = Standby/Green = Run
6. Red Container Full Indicator
7. Fan Speed Indicator & Air Cleaning Indicator
8. Humidistat Setting Indicator
9. Smart Control Setting Indicator
Smart Control
Your dehumidifier is fitted with a patented intelligent Smart Control System. We recommend that all
customers use the intelligent system, which automatically adjusts the running pattern of your Ebac
according to changes in the weather and your lifestyle.
To activate Smart
To activate Smart Control, press the mode button(4) until AUTO(9) is displayed on the control panel. The
unit should start in this mode automatically when connected to the mains. The unit will now automatically
adjust itself to work at the times needed to maintain the ideal conditions for your home. After starting to use
the unit for the first time it normally takes 2-4 weeks to get the humidity in your home under control. Once
signs of excess moisture have gone we would recommend that you switch to Economy mode by pressing
the mode button once until AUTO(9) and ECON are displayed on the control panel. The unit will still work
using Smart Control but for less time each day.
NOTE: Economy mode may not be suitable for all homes and /or at certain times of the year. If signs of
excess humidity return switch off economy by pressing the mode button until the control panel shows
AUTO(9) without ECON being lit.
(Model variant 1 as shown below for 2250e, 2650e and 2850e)
To Next Page
Loading...
Need help?
General
