Technical and safety information
Min Operating Temperature 3°C
Max Operating Temperature 35°C
Fuse Rating 13A
• Do not use the machine if the power cord or cabinet are damaged.
• If the flexible power cord is damaged it must be replaced by an identical cord which is
available from Ebac Limited or an Ebac authorised distributor.
• Do not poke objects into any grilles on the machine.
• This machine complies with EMC/RFI directive EN60555 (BS800).
• Ebac has a policy of constant development and, therefore, reserves the right to change
specifications without prior notice.
• Do not use the machine without the permanent drainage bung in place on the back of the
machine.
• To protect against electrical shocks, do not immerse unit, plug or cord in water, or spray
with liquids.
• Do not use an extension cord or double adapter.
• Ensure Power supply is RCD protected at 30mA.
Requesting service
Before requesting a service call please read the section 'If your Ebac 2000 fails to operate
correctly' and follow any advice this offers. If after following this advice you still experience
problems please obtain the following information then contact our customer service desk
on 01388 605061 (UK only)
1. Model and serial numbers (located on a rating plate behind the water container).
2. Your Name, Address, Postcode and Telephone Number.
3. Where your dehumidifier was purchased.
4. Date of purchase.
5. If applicable, any valid guarantee extension.
To Next Page
Loading...
Need help?
General
