Why does the power LED not come on for my EBARA A25S Water Pump?
If the Power LED does not come on for your EBARA Water Pump, it could be due to no power supply to the pump (check the power supply), the connector not being connected (connect the power connector), or the ELB not being ON (switch ELB ON).
How to fix abnormal noise and excessive vibration in EBARA A25S Water Pump?
If you are experiencing Abnormal noise or Excessive vibration with your EBARA Water Pump, it could be due to several reasons. The adjuster foot may not be lowered, so properly set all adjuster feet. The cover might be in contact with other items, so remove objects from the cover. The cover screws could be loose, so tighten the mounting screws. Also, a pump part could be damaged, so replace or overhaul the pump if needed.
What to do if I see ALARM: WATER FLOW LOW on my EBARA A25S?
If you see the ALARM: WATER FLOW LOW ##.# on your EBARA Water Pump, it could be due to several reasons: the coupler might be disconnected (connect it), the pressure may not be sufficient (apply sufficient pressure), the source valve could be closed (open the valve), the water piping might be clogged (clean or replace it), there could be leaks in the water piping (check the fittings), the instruments might be in failure (replace instruments), or the inlet/outlet might be reversed (connect correctly).
Instructions for connecting vacuum, exhaust, cooling water, and N2 gas piping.
Details on connecting the main power supply, including receptacle specifications.
Instructions and pin details for control signal connections for remote operation.
Table of common abnormal symptoms, check items, and corrective actions.
Lists alarm displays, symptoms, check items, and corrective actions.
Lists TRIP displays, symptoms, check items, and corrective actions.
Lists TRIP displays for optional features, symptoms, check items, and actions.
General| Brand | EBARA |
|---|---|
| Model | A25S |
| Category | Water Pump |
| Language | English |
To Next Page
