Eberhard Manufacturing Company
POWER-UP Locking System with Built-In Alarm
Wiring Breakdown
• Black Wire – Wire connection for chassis ground – 20 ga. Wire
Wire length = 3 feet 2-1/2 in.
Use supplied insulated ring terminal to make wire connection.
• Gray Wire – Wire connection to the parking light circuit on the vehicle – 20 ga. Wire
Wire length = 3 feet 2-1/2 in.
NOTES: 1) Drill and grommet all holes in vehicle as required to prevent accidental grounding.
2) Plastic connector on the end of the wire harness is not required. Customer to cut off
and discard. Use the supplied butt splice connectors and insulated ring terminals to
make the wire connections.
3) Jumpers on the 16835-4 Control Module need to be changed to the negative polarity
settings. Position the jumpers located on the bottom end of the control module on the
bottom two pins.
Rev. 9-11-2019 Page 13 of 36
To Next Page
Loading...