Eberhard Power-Up Plus - Wiring Breakdown; Base System with (7) Compartment Door Locks; Expansion System with (11) Compartment Door Locks; Expansion System with (8) to (18) Compartment Door Locks

Eberhard Manufacturing Company
POWER-UP Locking System with Built-In Alarm
Wiring Breakdown
Locate and mount 16835-4 Control module in a high position in front drivers’ side compartment. Make
sure the control module is in a position where it will not be damaged or come into contact with water.
Make wire connections as noted below:
For base system with (7) compartment door locks, connect wire harnesses as follows:
16835-4 Control Module to 1-16720-6 Cab Wire Harness to 2-16720-7 Compartment Wire
Harness.
For system with (11) compartment door locks, connect wire harnesses as follows:
16835-4 Control Module to 1-16720-6 Cab Wire Harness to 2-16720-7 Compartment Wire
Harness to 2-16720-10 Expansion Compartment Wire Harness.
For system with (8) to (18) compartment door locks, connect wire harnesses as follows:
16835-4 Control Module to 1-16720-6 Cab Wire Harness to 2-16720-8 Expansion Relay Wire
Harness to 2-16720-7 Compartment Wire Harness to 2-16720-9 Expansion Compartment Wire
Harness.
16835-4 Control Module and 16835-21 Antenna:
3 Pin JST Style Connector (male) to interface with the 3 Pin JST Style Connector (female) on the side of
the control module
16835-4 Control Module and 16835-22 Siren:
2 Pin Connector (male) to interface with the 2 Pin Connector (female) on the side of the control module
16835-4 Control Module and 16835-23 Actuator with Internal Switch Harness:
4 Pin Connector (male) to interface with the 4 Pin Connector (female) on the side of the control module
16835-4 Control Module and 16835-SS24 LED Harness:
2 Pin JST Style Connector (male) to interface with the 2 Pin JST Style Connector (female) on the side of
the control module
16835-4 Control Module and 1-16720-6 Cab Wire Harness with Dome Light Feature:
Terminal connections from outer terminal towards the center on control module:
• Terminal #1: Blue Wire – Motor connection for actuators – 12 ga. wire
• Terminal #2: Green Wire – Motor connection for actuators – 12 ga. wire
• Terminal #3: Red Wire – Wire connection for power from cab – 14 ga. Wire
• Terminal #4: Black Wire – Wire connection for chassis ground (actuators) – 14 ga. wire
• Terminal #5: Black Wire – Wire connection for chassis ground (actuators) – 14 ga. wire
Rev. 9-11-2019 Page 6 of 36