Eberhard Manufacturing Company
POWER-UP Locking System with Built-In Alarm
Miscellaneous
Setting for positive or negative polarity:
For positive polarity – Standard setting: Position the jumpers located on the bottom end of the
control module on the top two pins.
For negative polarity: Position the jumpers located on the bottom end of the control module on the
bottom two pins.
Programming the key fobs:
Make sure the system is unlocked and then disconnect the actuator with internal switch wire harness
from the control module prior to programming.
Press the program button on the side of the control module (3) times; the red LED will then light up.
Press button #1 on all of the key fobs that will be associated with the vehicle, (up to 4 key fobs),
within 10 seconds of the red LED lighting up. When the LED light goes off, the key fobs are then
programmed to the control module. Then, reconnect the actuator with internal switch wire harness to
the control module. Test each key fob by locking and unlocking the system to ensure proper
operation. NOTE: All key fobs must be programmed at the same time using this procedure.
Programming one key fob at a time will erase the previous programmed key fob.
Replacement Components:
• 1-16720-6 Cab Wire Harness: In-line fuse:
Power: 40-Amp fuse – ATC style fuse or equivalent
Signal: 5-Amp fuse – ATC style fuse or equivalent
Lights: 15-Amp fuse – ATC style fuse or equivalent
Dome Light Relay: 30-Amp - Replacement relay p/n: Hella Relay p/n: 49400B or equivalent
• 2-16720-8 Expansion Relay Wire Harness: Individual relay for each side of the vehicle.
Relay: 30-Amp - Replacement relay p/n: Hella Relay p/n: 49400B or equivalent
Power: 40-Amp fuse – ATC style fuse or equivalent
• 16835-15 Key Fob (Transmitter) Battery: 23AP (12V Alkaline), 23-279 (12V Alkaline) or equivalent
Rev. 9-11-2019 Page 14 of 36
To Next Page
Loading...