EasyManua.ls Logo

Eberhard Power-Up Plus - System Protection; Electrical Protection; Dome Light Function; 16720-1 Power Actuator Specifications

Default Icon
39 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Eberhard Manufacturing Company
POWER-UP Locking System with Built-In Alarm
System Protection
Electrical Protection:
16835-4 Control Module: Provides over-trigger protection for power actuators
1-16720-6 Cab Wire Harness: In-line fuse protection – 40 amp for output, 5 amp for processor &
15 amp for lights
2-16720-8 Expansion Relay Wire Harness: Individual relay for each side of the vehicle.
In-line fuse protection – 40 amp for power
System Protection:
16835-4 Control Module W/Dome Light Feature and Built-in Alarm:
Incorporates a “Lock Pulse Timer” to provide a 0.4 second pulse from the control module
to the actuators. If the buttons on the key fob are held down for an extended period, the
“Lock Pulse Timer” will prevent the actuators from being damaged by over firing.
Incorporates a “Time Out” feature that prevents damage to the actuators by shutting
down the system for 30 seconds if the buttons on the key fob are activated more than 8
times in a 30 second period. After the 30 second “Time Out” period, the system will
function as normal.
Can hold up to (4) key fobs with different signals. If any key fobs are lost or damaged and
needs to be replaced, the control module can learn/program new and/or additional key
fobs.
Can be set-up for use in either positive or negative polarity.
16835-4 Control Module – Dome Light Function:
Incorporates a feature to activate/deactivate dome lights for up to 18 compartments. On
the key fob, when Button #2 (Unlock) is depressed, the dome lights will be activated for
10 minutes. When Button #1 (Lock) is depressed, the dome lights will be turned off.
Optionally, when Button #1 (Lock) and Button #3 (N/A) are depressed at the same time,
the dome lights will be activated for 10 minutes. By depressing Button #1 (Lock) and
Button #4 (N/A) at the same time, the dome lights will be turned off.
16720-1 Power Actuators:
Working voltage: 8.8 VDC to 13.7 VDC
Current absorption: 4.5 A (Max.)
Temperature range: -18.4° F to +188.6° F
Power: 7.8 lbf.
16835-1 Power Actuator with Internal Switch:
Same specifications as 16720-1 Power Actuator
Has an internal switch for manual key override for all actuators
16835-15 Key Fob (Transmitter):
Working range of 150 feet. Maximum
Frequency = 433.92 MHz, Rolling Code
Separate “Lock” & “Unlock” Buttons
Rev. 9-11-2019 Page 4 of 36