Eberhard Power-Up Plus - 1-16746-U Illuminated Power 3 Way Toggle Switch Kit W;Connectors

Eberhard Manufacturing Company
POWER-UP Locking System with Built-In Alarm
Wiring Breakdown
Make wire connections as noted below:
• Purple Wire – Wire connection to the Green/White lock circuit from the 1-16720-6 Cab Wire
Harness – 20 ga. wire
Wire length = 3 feet 2-1/2 in.
Use supplied butt splice connector to make wire connection.
• Brown Wire – Wire connection to the Blue/White unlock circuit from the 1-16720-6 Cab Wire
Harness – 20 ga. Wire
Wire length = 3 feet 2-1/2 in.
Use supplied butt splice connector to make wire connection.
• Black Wire – Wire connection for chassis ground – 20 ga. Wire
Wire length = 3 feet 2-1/2 in.
Use supplied insulated ring terminal to make wire connection.
NOTES: 1) Drill and grommet all holes in vehicle as required to prevent accidental grounding.
2) Plastic connector on the end of the wire harness is not required. Customer to cut off
and discard. Use the supplied butt splice connectors and insulated ring terminal to make
the wire connections.
3) Jumpers on the 16835-4 Control Module need to be changed to the negative polarity
settings. Position the jumpers located on the bottom end of the control module on the
bottom two pins.
1-16746-U Power 3 Way Toggle Switch Kit W/Connectors:
Illuminated toggle switch for the compartment door locks to a cab without an OEM power locking
system.
Locate a position for mounting and cut a .93” wide x 1.74” tall opening to receive the trim plate and
toggle switch. Trim plate will fit a panel of .08” to .16” thick.
Make wire connections as noted below:
• Purple Wire – Wire connection to the Green/White lock circuit from the 1-16720-6 Cab Wire
Harness – 20 ga. wire
Wire length = 3 feet 2-1/2 in.
Use supplied butt splice connector to make wire connection.
• Brown Wire – Wire connection to the Blue/White unlock circuit from the 1-16720-6 Cab Wire
Harness – 20 ga. Wire
Wire length = 3 feet 2-1/2 in.
Use supplied butt splice connector to make wire connection.
• Black Wire – Wire connection for chassis ground – 20 ga. Wire
Wire length = 3 feet 2-1/2 in.
Use supplied insulated ring terminal to make wire connection.
Rev. 9-11-2019 Page 12 of 36