Need help?Do you have a question about the EBS MULTICOMP and is the answer not in the manual?
Input Specifications| nominal input level | -10 or -4 dBv |
|---|---|
| input impedance | 700 kohms |
| bandwidth | 20 - 20k Hz |
Gain and Compression| gain range | 0 - 15 dB |
|---|---|
| compressor ratio min/max | 1:1 - 5:1 |
| threshold | -25 - +6 dB |
Time Constants| attack time | <7 ms |
|---|---|
| release time | typ. 70 ms |
Power| power requirements | 9 - 12 V DC Regulated, 35 mA max |
|---|---|
| over voltage protection | up to 18 V |
Weight and Dimensions| width | 2.8" (70 mm) |
|---|---|
| height | 4.5" (115 mm) |
| depth | 1.4" (35 mm) |
| weight | 400g (0.88 lb.) |
Selects input stage for active or passive instruments/effects loop connection.
Adjusts the amount of compression, from 1:1 to 5:1 ratio.
Manages output level, compensating for compression or boosting sound.
Chooses between TubeSim, MultiBand, or Normal compression modes.
Dynamically shows compressor activity when the pedal is active.
Engages or bypasses the pedal's effect.
Recommended power source, 9-12V DC, center negative connector.
Pedal accepts a 9V battery; installation instructions are provided.
Fine-tunes high/low band compressor thresholds independently via internal trimmers.
Setting for rhythmic guitar chords with mid-heavy compression and tube simulation.
For percussive funky playing, utilizing multi-band compression for clarity.
Achieves a swelling chord effect with fast attack and heavy normal compression.
To Next Page
