Ebyte ME31-XXAX0060 - OLED Display and Parameter Configuration; Information Display Interface; Equipment Parameter Display Interface

Chengdu Ebyte Electronic Technology Co.,Ltd. ME31-XXAX0060_UserManual_EN
Copyright ©2012–2023, Chengdu Ebyte Electronic Technology Co.,Ltd
18
Check digit: NONE(00);
(1) Baud rate：
Baud rate code value table
0x0000
1200
0x0001
2400
0x0002
4800
0x0003（default）
9600
0x0004
19200
0x0005
38400
0x0006
57600
0x0007
115200
(2) Check Digit：
Check Digit
0x0000(default)
NONE
0x0001
ODD
0x0002
EVEN
4.5 OLED display and parameter configuration
The display interface includes an information display page (DO status display page) and a parameter setting
page (partial parameters).
4.5.1. Information Display Interface
Including the DO status display page, short press the up and down buttons to switch the interface.
4.5.2. Equipment parameter display interface
Press the left or right button to enter the password input interface, complete the correct password input, and
display the device parameter information interface (password interface: default password: 0000. Short press the
middle to verify the password; The left and right buttons can switch the password bit; Up and down keys can
switch the value of the current bit. The password has a total of 4 digits, and each input is a number ranging from
0-9):
The parameter setting interface from top to bottom is:
1. Modbus address;
2. Baud rate;
3. Data bits;
4. Check Digit;
5. Stop bit;