Eccotemp L10 - Electrical Wiring; Replacement Parts

ENGLISH
PLEASE NOTE: THIS MODEL IS NOT RECOMMENDED, NOR HAS IT BEEN TESTED FOR ANY PERMANENT OR INDOOR INSTALLATION. THIS
MODEL IS PART OF OUR PORTABLE, OUTDOOR SERIES AND NEEDS TO BE TAKEN DOWN AND STORED IN A WARM, DRY PLACE AFTER EVERY
USE. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. VISIT SUPPORT.ECCOTEMP.COM FOR THE
LATEST VERSION OF THE MANUAL AND WARRANTY.
18
Support: Support.Eccotemp.com Shop Online: Eccotemp.com Store Locator: Eccotemp.com/locator
For more available parts for your Eccotemp Water Heater and to
purchase, visit www.eccotemp.com/parts or call 1-866-356-1992.
Electrical Wiring
Replacement parts
This connection is for low-voltage batteries or direct current only. Do not connect 120 or 240 volts AC.
NOTICE - If any of the original wire as supplied with the appliance shall
be replaced, it shall be replaced with the original type wire or its temperature
equivalent.
TROUBLESHOOTING
NONOTITICECE -
-
IfIf aanyny ooff ththee ororigigininalal wwiriree asas ssupupplplieiedd wiwithth tthehe aapppplilianancece sshahallll
CAUTION: Label all wires prior to
disconnection when servicing controls.
Wiring errors can cause improper and
dangerous operation. Verify proper
operation after servicing.
Ignition pin
Sensor pin
Ignition controller
Ground wire
Over temp sensor
Solenoid
Battery box
Temperature sensor
Display
HV1 HV2 S
REPLACEMENT PART SKU
Battery
Box
1001026
1/2” NPT
to Garden
Hose
Adapter
502028
Gas
Regulator
and Hose
502005
REPLACEMENT PART SKU
Hardware
Pack
CSAL10HWP
Pressure
Relief
Valve
22454877