7
5. Attach shower nozzle to the fitting marked ―Water Outlet‖
(middle connection). Connect using hand pressure
ONLY. If installing in an existing water system, connect
the hot water line directly to the ½‖ NPT/BSP fitting.
6. Install two ―D‖ cell batteries in the compartment on the
bottom left of the heater. Check that batteries are facing
the correct direction.
7. Use the top tab on the unit to suspend from a screw
adequate to holding 15 pounds/6.8 KG. Place at a
comfortable height without putting stress on the gas hose.
If the unit is to be permanently mounted, use screws to
attach the bottom tab firmly. DO NOT USE SUSPENDED
FROM THE HANDLE!
8. Attach gas regulator with hose to the LP tank. Use hand
pressure only on the plastic connector. LEAVE GAS
TANK VALVE IN THE ―OFF‖ POSITION‖
To Next Page
Loading...
Need help?
General
