9
OPERATION - INTRODUCTION
This operation procedure guides you through a typical process on how to set a
M.O.L.E.
®
Profiler up for performing a data run. For additional detail, consult the Help
System in the software.
The M.O.L.E.
®
Thermal Profiler depends on the MAP (Machine-Assembly-Process)
software to control how it collects and interprets data. Several kinds of data runs may
need to be performed to achieve desired information, or the same data run may be
performed repeatedly over time to monitor one process. Either way, each data run must
be set up at least once.
The MAP software includes wizards that help you get started quickly, even if you are a
beginner or infrequent user.
To Next Page
Loading...
