ECD V-M.O.L.E. - Running the Data Collection Process

2
3
4
16
When retrieving the M.O.L.E.® Profiler and
test product use caution as it may be warm.
2. Connect the M.O.L.E Profiler to the sensors.
3. Press the M.O.L.E. Profiler "ON" button.
4. Place the M.O.L.E. Profiler in the appropriate
Thermal Barrier and press the "Record" button.
5. Close the Thermal Barrier making sure the sensor
wires do not get pinched.
6. Pass the thermally protected M.O.L.E.® Profiler,
and test product through the process.
OPERATION - DATA COLLECTION