English
English
34
If your router has WPS, you can connect directly to the modem/router without entering a password or adding
a network rst. Select WPS on your router and press OK. To connect, press the WPS button on your modem/
router. After the devices have connected, a conrmation message will appear on your TV. Select OKto continue.
No further setup is required.
Highlight Connection speed test and click OK to check the speed of your Internet connection. Highlight
Advanced Settings and click OK to open the Advanced Settings menu. Use the directional and numeric
buttons to adjust the settings. When you are done and want to save the settings, highlight Save and press OK.
More information
If a connection is established, the connection status is displayed as Connected or Not Connected and the
current IP address.
Connect your mobile device via WLAN
• If your mobile device is WLAN-enabled, you can connect it to your TV via a router to access your device's
content. In this case, your mobile device must have the appropriate sharing software.
• Follow the steps in the previous chapter to connect your TV to the router.
• Then connect your mobile devices to the same router (same Wi-Fi network) and launch the selected UPnP/
DLNA casting app on your mobile device. Then select the les you want to share with your TV.
• If the connection is established correctly, you should now be able to access shared les from your mobile
device via Audio Video Sharing, which is included with your TV.
• Highlight Audio and Video Sharing in the Sources menu and press OKto see the available devices on the
network. Select your mobile device and press OK to continue.
• If available, you can download the virtual remote control app from your mobile app provider's server.
Note: This feature may not be supported on all mobile devices.
Network standby mode
Network standby is a standard that allows you to turn on or wake up the device via a network message. The
message will be sent to the device via a program running on a remote device that is connected to the same
local network as the smartphone.
Your TV is WoWLAN compatible. This feature may not be available during the First Installation process. To
enable this feature, set the Network Standby option in the Network menu to On. The device from which the
network message will be sent to the TV and the TV must be connected to the same network. Network Standby
is only supported for Android devices and can only be used through the YouTube and Netix apps.
To use this feature, the TV and remote device should be connected while the TV is on. If the TV is switched o,
the connection should be restored the next time you switch it on. Otherwise, this option will not be available.
This does not apply when the TV is switched to standby mode.
The performance of some devices on the market may vary depending on the software architecture. To use
the Network Standby feature with better performance, make sure your device has the latest rmware version.
If you want your TV to consume less power in standby mode, you can disable this feature by setting Mains
Standby to O.
Wireless screen
Wireless screen is the standard for streaming video and audio content. This feature provides the ability to use
the TV as a wireless display device.
Use with mobile devices
There's an easy way to project the content of your mobile device's display onto your TV. This way you can view
(mirror) photos, videos and other content from your mobile device's display on the big screen TV. This feature
also allows you to play audio.
Make sure your mobile device and TV are connected to the same router/ Wi-Fi network. Then press the Source
button on the remote control and scroll to the Wireless Display sources.
A screen will appear to indicate that the TV is ready to connect.
To Next Page
Loading...
