CARE & MAINTENANCE ECHELON FITNESS | STRIDE-6
16
ECHELON FITNESS // STRIDE-6 // INSTRUCTION MANUAL
CARE & MAINTENANCE
Weekly | 2-a
Daily
1. Power off the treadmill and clean any high-use areas, like
the handlebars and console, with a non-acidic cleaner (NO
ammonia, chlorine, or alcohol) on a soft cloth. Do not spray
cleaning solution directly on the treadmill as that could ruin
any electrical components.
2. Inspect the power cord for damage. If damaged, replace
immediately by contacting Customer Service.
Note: When the treadmill is not in use, unplug and store the
power cord in a secure, dry area and away from children.
3. The safety key should be removed after each use.
4. Inspect for any noises that could indicate potential issues.
If a troubling noise is indicated please contact
Customer Service.
Weekly
1. Clean the running belt, console, uprights, and motor cover
with non-acidic cleaners and a soft cloth. Cleaners should be
applied to the cloth and never sprayed onto the equipment
directly.
2. Inspect all the assembled and pre-assembled hardware
and tighten or re-secure as-needed. This includes but is
not limited to the following:
a. Handlebars & Uprights
b. Tablet
c. Running Belt
3. Dust and vacuum the treadmill and the surrounding area. To
clean underneath the treadmill, turn off the power, fold, and
roll the treadmill to an alternate location. Return the treadmill
to its original location after cleaning.
4. Ensure your app and equipment firmware are up-to-date with
the latest versions.
5. Check the belt for any looseness, this will cause the treadmill
to recieve improper info when calculating metrics if it is not
properly tightened. When tightening make sure to adjust
both sides of the rear roller evenly with the provided Allen
Wrench, turning clockwise to tighten there should only be a
2 - 3 inch gap when lifting the belt. Do not tighten the belt
rollers in excess of 10 full rotations, doing so could damage
components of the treadmill. If you feel as if you have done
this make sure to start working backwards to correct any
overtightening. If these steps do not correct the issue, please
resort to the belt lubrication instructions, or call our customer
service if you require further assistance.
Monthly
1. Check the alignment on the treadmill running belt
by ensuring it is centered and glides smoothly over
the running deck. Utilize the instructions located
in your user manual for “re-centering” the belt
to troubleshoot and fix. Refer to page 15 for belt
adjustment instructions.
2. Start the treadmill at a low speed and test for any
slippage of the belt to ensure the motor is applying
the proper torque.
3. If you hear any rubbing noises, find the treadmill
belt off-center beyond the provided instructions, or
encounter damage to the running deck, please stop
treadmill usage and contact Customer Service for
assistance.
Echelon Fitness Customer Service:
(833) 937-2453
cs@echelonfit.com
To Next Page
Loading...
