Running belt deviation adjustment:
All running belts are properly set at the factory and after assembly. However, after a
period of use, belt deviation might occur. The reasons might be as follows.
① The treadmill is not placed in level surface.
② The user don’t run in the center of the running belt.
③ The user don’t apply even force on both feet.
When this deviation occurs, the running belt can run several minutes without load, to
return to normal. But if not, turning left or right adjusting bolt 1/4 turn clockwise with Allen
Wrench until centered.
KEY POINT:
-Clockwise means tighten.
-Anti-clockwise means loosen.
-Running belt will shift to the loose side.
①If the running belt shifts to the left, that means the left side is too loose.
Adjust the left bolt clockwise to make the left tighter.
Or adjust the right screw anti-clockwise to make the right looser.
②If the running belt shifts to the right, that means the right side is too loose.
Adjust the right bolt clockwise to make the right tighter
Or adjust the left screw anti-clockwise to make the left looser.
For right deviation.
adjust the right bolt clockwise or the left bolt
anti-clockwise.
for left deviation,
Adjust the left bolt clockwise or the right bolt
anti-clockwise.
tight
loose
loose
tight
To Next Page
Loading...
