How to lubricate the belt:
Step 1: Stop the running belt, and fold the treadmill.
Step 2: Lift up the running belt from the back of main frame
and put the silicone oil bottle as far as to middle of the belt,
spray silicone oil starting from the middle of running belt then
to two sides.
Step 3: Unfold the treadmill and run the treadmill at a speed
of 1km/h to apply silicone evenly, tread lightly on the running
belt from left to right for several minutes to let belt absorb the
silicon spray.
Cleaning
Regular cleaning of the running belt ensures a long product life.
Warning: The treadmill shall be turned off to avoid electrical shocks. The power cord shall
be pulled out of the socket, before starting the cleaning or maintenance.
After training: Wipe the console and other surfaces with a clean soft and damp cloth
to remove sweat residues.
Caution: Do not use any abrasives or solvents. To avoid damage to the console,
keep any liquids away. Do not expose the console to direct sunlight.
Weekly: To make the cleaning easier it is recommended to use a mat for the treadmill.
Shoes can leave dirt on the running belt that can fall beneath the treadmill. Clean the
mat under the treadmill once a week.
Storage: Store your treadmill in a clean and dry environment. Ensure power off and
the power cord is unplugged from the electric socket.
Running belt tension adjustment
All running belts are properly set at the factory and after assembly. However, after a
period of use, loose belt may occur, and the user might feel pause or slipping belt. Adjust
the running belt tension by turning left and right adjusting bolt 1/4 turn clockwise with Allen
Wrench until proper tension.
Proper running belt tension is important, if loose belt, the running belt and the roller will
slip in turn. But too tight, it increase the load of the motor and damage the motor, running
belt and roller, etc.
tight
loose
loose
tight
To Next Page
Loading...
