319 INCH CHIPPER
ENGLISH
Section
7 SPECIFICATIONS
*Use of medium strength thread locker required.
**If removing cap to program, cap and rubber washer must be reinstalled to correct torque to maintain IP67 seal.
SPECIAL TORQUE REQUIREMENTS
LOCATION HARDWARE DESCRIPTION
TORQUE
(UNIFIED INCH)
TORQUE
(METRIC)
Controller mounting hardware* 8-32 screws 20 in-lbs. 2.26 Nm
Back of controller USB seal cap** 20 oz-in 0.14 Nm
DESCRIPTION ENGLISH METRIC
Overall size (L × W × H) 127" × 79" × 100" 323 cm × 201 cm × 254 cm
Overall weight 2725 lbs. 1236 kg
Max chipper capacity 9" diameter 22.9 cm diameter
Chipper blades 4 reversible (5" × 4" × 0.5") 4 reversible (12.7 cm × 10.2 cm × 1.3 cm)
Chipping anvil 9" × 4" × 0.625" 22.9 cm × 10.2 cm × 1.6 cm
Rotor speed 1600 RPM
Rotor size 30" diameter × 1.25" 76 cm diameter × 3.18 cm
Rotor weight 275 lbs. 125 kg
Discharge tube size 8" 20.3 cm
Drive type Belt
Drive belt size 3B90 (93") 3B90 (236.2 cm)
Hydraulic belt size BX30 (33") BX30 (83.8 cm)
Tire size ST205/75R15
Jack 1000 lb. rating 454 kg rating
Engine 2.2 L Diesel Kubota
®
Fuel tank capacity 18 gal. 68 L
Hydraulic feed rate 0-120 fpm 37 m/min
Hydraulic oil tank capacity 3 gal. 11.4 L
To Next Page
Loading...
Need help?
General
