To Next PageTo Next PageWhat to do if there is no spark at the spark plug in my Echo CS-320TES?
If there's no spark at the spark plug, the spark gap might be incorrect and needs adjustment to 0.6 to 0.7 mm. The spark plug could also be covered with carbon or fouled with fuel, requiring cleaning or replacement. If the spark plug is defective, replace it.
How to fix no fuel at the carburettor of my Echo Chainsaw?
If there's no fuel at the carburettor when you crank your Echo Chainsaw, the fuel filter or fuel line might be clogged and require cleaning or replacement. The carburettor itself may also be clogged and need to be cleaned. If you are not sure, ask your ECHO dealer.
What to do if there is no spark at the end of the plug wire of my Echo CS-320TES?
If there's no spark at the end of the plug wire, check if the ignition switch is turned off and turn it on. If the switch is already on, there may be an electrical problem. If you are not sure, ask your ECHO dealer.
Why does my Echo CS-320TES engine run poorly and then die?
Your Echo Chainsaw engine might run poorly and die due to several reasons. The air filter or fuel filter could be dirty and need cleaning or replacing. A plugged fuel vent, a faulty spark plug, or a misadjusted carburettor could also be the cause. Additionally, check if the cooling system or exhaust port/silencer are plugged and clean them if necessary.
Why is the silencer of my Echo CS-320TES wet with fuel?
If the silencer is wet with fuel, the fuel mixture might be too rich, try opening the choke. Also, the air filter may need cleaning or replacement, or the carburettor may need adjustment. If you are not sure, ask your ECHO dealer.
General| Chain Pitch | 3/8 in |
|---|---|
| Power Output | 1.5 kW (2.0 HP) |
| Bar Length | 30 cm |
| Weight | 3.4 kg |
| Chain Gauge | 0.050 in |
Specific safety rules for using the saw in tree service.
Step-by-step guide for starting a cold engine.
Explains correct use and testing of the chain brake.
