15
DCS-5000
99922205708
© 08/2021 ECHO Incorporated
SAFETY
Release the chain brake
• When front hand guard is fully
pulled rearward, chain brake is
released.
Do not allow the saw to tip forward in order to avoid damage to the
chain.
If the chain does not stop immediately, return the saw to your
authorized dealer for repair.
Note:
• For practice, while cutting a small tree, push the lever forward to lock
the brake.
• Conrm that the brake works properly before each use.
• If the chain brake is clogged with wood chips, function of the brake may
deteriorate. Always keep the device clean.
• Do not increase motor RPM while the chain brake is locked.
Do not use a bar and chain combination other than those specied in this
manual.
For your own safety, do not remove the chain brake system.
The installation of a chain brake may be mandatory by law or as stipulated
by insurance regulations in your area of operation. You should inquire
through local government ofces, your employer or your local dealer to
ensure that your chainsaw conforms to the required safety standard.
Chain brakes have been designed and tested to comply with international
safety standards as follows:
UL 62841-1, UL 62841-4-1, CAN/CSA C22.2 No.62841-1, CAN/CSA C22.2
NO. 62841-4-1
To Next Page
Loading...
Need help?
General