HEDGE CLIPPER
OPERATOR'S MANUAL
25
LUBRICATION
Blades
Level 1.
Tools required: Clean rag, 25 or 50 mm (1 or 2 in.) medium bristle paint
brush
Parts Required: 20W Engine Oil (lubrication), 50-50 mixture of kerosene
and 20W oil (cleaning).
WARNING DANGER
Hedge Clipper Blades are very sharp. Wear gloves to protect
hands.
1. Disconnect spark plug wire from spark plug.
2. Brush loose debris from blade and coat both sides of blade with the
50-50 cleaning mixture.
3. Allow cleaning mixture to soften the remaining gummy residue then
wipe it from the blade.
4. Apply clean oil to the entire length of the blade. Be certain the
blade bolts are lubricated.
5. Wipe excess oil from the blade before putting the unit back in
service.
3. HI speed adjustment.
Adjust HI (A) needle with tachometer. Refer to Wide Open Throttle
RPM settings listed in "Specifications" on page 12.
4. Check idle speed and reset if necessary. If tachometer is available,
idle speed should be set to the specifications found on page 12
"Specifications" of this manual.
WARNING DANGER
When carburetor adjustment is completed, blades should not move
at idle, otherwise serious personal injury may result.
To Next Page
Loading...
Need help?
General
