Echo Power Pruner PPT-265ES - Throttle Linkage and Ignition Leads Connection

POWER PRUNER
TM
OPERATOR'S MANUAL
13
THROTTLE LINKAGE AND IGNITION LEADS
 &ORVHFKRNHDQGUHPRYHDLU¿OWHUFRYHU
2. Place throttle cable (A) and brass cable guide (B) through adjust-
PHQW¿[WXUH&)XOO\VHDWEUDVVFDEOHJXLGHLQDGMXVWPHQW¿[WXUH
and seat cable end into large hole in carburetor swivel (D).
 5RWDWHWKHDGMXVWPHQW¿[WXUHVRWKDWWKHQRWFK(IDFHVHQJLQH
 ,QVHUWRQHHQGRIFOLS)LQWRQRWFKLQWKHDGMXVWPHQW¿[WXUH
5. Push clip to fully seat both ends into notch.
6. Assure both ends of clip are secured in notch as shown. Con-
¿UPWKDWWKHWKURWWOHFDEOHGRHVQRWPRYHZKHQEUDVVFDEOHJXLGH
(B) is pulled. Check throttle for freedom of movement and that
wide open throttle / low idle extremes are adjusted properly. The
WKURWWOHOLQNDJHPXVWEHDGMXVWHGE\PRYLQJWKHDGMXVWPHQW¿[WXUH
Consult with your Echo Dealer for correct adjustment procedure.
E
F
A
D
C
B
E
F
B