27
DPAS-2100
99922205734
© 08/2021 ECHO Incorporated
Problem Possible Cause Solution
The line does
not advance.
Lines are welded to
themselves.
Lubricate with silicone spray.
Not enough line on
spool.
Install more line.
Lines are worn too
short.
Advance the cutting line.
Lines are tangled on
spool.
1. Remove the lines from the spool.
2. Wind the lines.
The line
keeps break-
ing.
The machine is used
incorrectly.
1. Cut with the tip of the line, avoid
stones, walls and other hard objects.
2. Advance the cutting line regularly to
keep full cutting width.
Grass winds
around the
trimmer head
and motor
housing.
Cut tall grass at ground
level.
1. Cut tall grass from the top down.
2. Remove no more than 8" in each
pass to prevent wrapping.
The line does
not cut well.
The cut-off knife
becomes dull.
Sharpen the cut-off knife with a le or
replace it.
Heavy
vibration.
The length of line on
one side is longer than
the other side.
Make sure that the line on both sides
is equal in length. Advance the line.
TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
