Echo SRM-210 User Manual

GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL
13
NYLON LINE INSTALLATION
Tools Required: None
Parts Required: Two (2) Pre-cut Nylon Line 8 in. X .095 in.
1. Shut engine off. Lay unit on the ground with head assembly up.
2. Remove old nylon line through center recess of head.
3. Thread new lines through outside holes (A) in housing until ends
meet in center of recess.
NOTE
Insert cutting line ends to center of head recess to insure easy
removal of used lines.
FRONT HANDLE INSTALLATION
Tools Required: Screwdriver.
1. Position front handle for comfortable operation and secure screws.
A

Echo SRM-210 Specifications

General

Engine Displacement	21.2 cc
Shaft Type	Straight
Engine Type	2-stroke
Fuel Capacity	400 ml
Cutting Width	17 inches
Fuel Tank Capacity	0.41 liters
Starter System	i-30