SRM-3020T MAINTENANCE
X7502350100 41
© 04/2018 ECHO Inc.
ENGLISH
4. Hold trimmer head while
turning knob clockwise to wind
line onto spool until about
13 cm (5 in.) of each line
remains exposed.
Trimmer head is now fully loaded
and ready for operation.
When the wear indicators
located at the bottom of the
Speed-Feed
®
head are worn
smooth, or if holes appear,
replacement of the cover or the
entire Speed-Feed
®
head is
required.
Sharpening Metal Blades
Several styles of metal blades are approved for use on the Brush Cutter.
The 8-tooth blade can be sharpened during normal maintenance. The
clearing blade and 80-tooth blade require professional service.
To Next Page
Loading...
Need help?
General
