Echo TC-210 - Page 21

X7504083609 21
© 4/2016 ECHO Inc.
TC-210 OPERATION
Move choke lever (B) to Cold Start
Position ( ). Throttle must remain
at idle for starting.
4. Purge Bulb
Pump purge bulb (C) 5-10 times until
fuel is visible and flows freely in the
clear fuel tank return line.
5. Recoil Starter
Firmly hold unit down. Pull recoil starter
handle/rope (D) until engine fires, or a
maximum of five (5) pulls.
6. Choke
Move choke lever (B) back to Run
() position.
7. Recoil Starter
Pull recoil starter handle/rope (D) until
engine starts and runs, or a maximum of
10 pulls.
Note: If engine does not start with
choke in “Run” position after 10
pulls, repeat instructions 3 - 6.
8. After starting the engine, allow unit to
warm up at idle for 2-3 min.
9. Throttle Trigger
After engine warm-up, gradually
depress throttle trigger to increase
engine RPM to operating speed.
B
C
D
B
C
D