OPERATION TC-210
22 X7504083609
© 4/2016 ECHO Inc.
Starting Warm Engine
The starting procedure is the same as Cold
Start except DO NOT close the choke.
1. Stop Switch
Move stop switch button (A) to RUN
position.
2. Purge Bulb
Pump purge bulb (C) until fuel is
visible in the “Clear” fuel return line.
Pump bulb an additional 4 or 5 times.
3. Recoil Starter
Firmly hold unit down. Pull recoil starter
handle/rope (D) until engine starts and
runs, or a maximum of five (5) pulls.
Note: If engine does not start after 5
pulls, use Cold Start Procedure.
Stopping Engine
1. Throttle Trigger
Release throttle trigger and allow
engine to return to idle before shutting
off engine.
2. Stop Switch
Move stop switch button (A) backward to
STOP position.
If engine does not stop when stop switch is moved to STOP
position, move choke to COLD START position to stall engine. Have
your ECHO dealer repair stop switch before using unit again.
To Next Page
Loading...
