Echo WP-1000

8 X7505120800
© 4/2015 ECHO Inc.
SAFETY WP-1000
Water can be a conductor of electric current when exposed
to live electrical wiring. Electrocution will result.
• Do not operate pump in flooded basements without first
shutting off electricity from outside the house. Pump
should be located outside in a vented area.
• Do not operate pump in flooded areas near power lines
unless electric service has been disconnected.
Read the Manuals
• Provide all users of this equipment with the Operator’s Manual
for instructions on Safe Operation.
Clear the Work Area
• Spectators and fellow workers must be warned, and children
and animals prevented from coming nearer than 15 m (50 ft.) while the unit is in use.
Avoid Hot Surfaces
• Keep exhaust area clear of flammable debris. Avoid contact
during and immediately after operation.
Equipment
Use only ECHO attachments. Serious injury may result from the use of a non-approved attachment
combination. ECHO, INC. will not be responsible for the failure of cutting devices, attachments or
accessories which have not been tested and approved by ECHO. Read and comply with all safety
instructions listed in this manual.
Before operation a complete check of the unit must be performed:
• Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace as needed.
• Inspect guards and shield for damage and that shield is securely in place. Replace if sjield is damaged or
missing.
• Do not operate the pump without an air filter. Rapid engine wear will result.
• Ventilating openings such as crankcase ducts, engine cover, air filter and muffler exhaust outlet must be
cleaned periodically and kept free of debris to ensure proper operation and adequate cooling of the engine
and pump.
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects
away from all openings.
◆ ALWAYS stop engine, disconnect spark plug, and make sure all moving parts have come to a complete
stop before removing obstructions, clearing debris, or servicing unit.
◆ DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.