Echo X Series - Starting Warm Engine

HCS-2810 / 3810 OPERATION
X7702248300 21
© 09/19 ECHO Incorporated
5. Choke
After engine fires (or 5 pulls),
move choke (B) to the RUN
( ) (OPEN) position. Restart
engine if necessary and allow
unit to warm up at idle for
several minutes.
Note: If engine does not start with choke in “RUN” position after 5
pulls, repeat instructions 2 - 5.
The blades must not move at idle, otherwise serious personal
injury may result. Periodic carburetor adjustment may be
necessary to assure blades do not move at idle. If blades move,
readjust carburetor according to “Carburetor Adjustment”
instructions in this manual or see your Dealer.
6. Throttle Trigger
After engine warm-up, grip the throttle handle with left hand and support
handle with right hand. Depress the throttle trigger lockout, and gradually
depress throttle trigger to increase engine RPM to operating speed.
Starting Warm Engine
The starting procedure is the same as Cold Start except DO NOT close the
choke.
The blades must not move at idle, otherwise serious personal
injury may result. Periodic carburetor adjustment may be
necessary to assure blades do not move at idle. If blades move,
readjust carburetor according to “Carburetor Adjustment”
instructions in this manual or see your Dealer.
C
C
B