15
Installation Guide
15
tel - 1-800-477-2267
email - support@aampglobal.com
Illustrations are typical and may not match exact vehicle detail
Step 3
Remove the three Torx T30 screws holding the
mirror to the door of the truck.
One of the Torx T30 screws has a small cap
covering it. Use something slim to pry the cover
off to access the screw.
The mirror arm will still be held on with a clip on
the outside.
Step 4
Using a nylon pry tool, insert it (approximately as
shown - above the hook) then pull it out and push
the mirror assembly up to disengage.
Step 5
Feed a long wire tie or similar sh tool through the door
to where the factory wires come through the boot.
FCTP-MB1903
Sprinter Tow Package
To Next Page
Loading...
