14
Installation Guide
14
tel - 1-800-477-2267
email - support@aampglobal.com
Illustrations are typical and may not match exact vehicle detail
Step 9
Disconnect the turn signal indicator.
Place the turn signal indicator in a safe area
to avoid damage.
Cable Routing
Mirror Disassembly (continued)
NOTE
Removing the mirror assembly is not absolutely
necessary but makes the installation easier.
FCTP-MB1903
Sprinter Tow Package
Step 1
For the tow mirror, fold the arm in towards the door to
gain access to the inner hinge area. Feed a long wire tie
or similar sh tool through the lower outside portion of
the tow mirror arm. Tape the camera cable to the end of
the wire tie you are using to feed the wire through. It may
be necessary to split the plastic pieces at the bottom of
the arm to allow the connector to pass through.
Step 2
Feed a long wire tie or similar sh tool through the mirror
where the factory wires come through. Tape the camera
cable to the end of the wire tie you are using to feed the
wire through.
Non-Tow Mirror
Tow Mirror
To Next Page
Loading...
